![]() ![]() Just before you want to load your samples on the gel, thaw them a bit and centrifuge them. You can mix them with master mix, heat them, and after that, store them. But I want to point out that you can go a step further and prepare your samples and store them. Ok, you probably know that you can store your samples at -20☌. If it is hard to wrap it in a towel due to the equipment, you can wrap the whole thing in cellophane wrapping or put it in a plastic bag. Then put the gel in a plastic bag or box. To do so, remove the comb and wrap each gel separately in paper towels, and wet everything with dH 2O. Whichever equipment you use, it is important to keep the gels wet. I can store the gels in each case, but it is easier with the Mini-protean III because I can remove the gels from the casting stand and casting frames without the plates separating. For example, I am using Mini-protean II and III. How to store it? Well, first it depends on which equipment you use. Of course, this doesn’t mean that you can leave it there forever, but for two weeks, it is ok. Gels can be prepared ahead of time and stored at 4☌ (fridge). Thaw it just before use.Īlternatively, if you run SDS-PAGE gels frequently, you can keep your APS in the fridge at 4☌ for about a month before it goes bad. But it turns out that is ok to dissolve it, aliquot it, and store it at -20☌. ![]() At first, I was making fresh APS each time before electrophoresis. Yes, it can be aliquoted and stored at -20☌ for long-term storage. In that case, put a label on the bottle of your buffer where you can put a stripe each time you use it, so it is easy to follow usage. Some labs also reuse the gel running buffer a few times. One more option is to make them 10x concentrated. You can make all your gel buffers in large amounts at one time and use them as you go along. You might already know this, but it is not bad to repeat it. Here is a list of components that you can store and use later: Buffers Here are some SDS-PAGE tips and tricks that I learned to help you save time: Make Stuff Ahead of Time As a beginner in my lab, I had little help, so my first SDS-PAGE gel took two whole days! Since then, I’ve learned a lot about how to make the process faster. Today, SDS-PAGE is one of the basic methods in biology labs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |